Products Support > GSX Support FSX/P3D
GSX config not saving as it should? **SOLVED**
goesto11:
--- Quote from: bcincin on August 28, 2022, 05:00:10 pm ---The only problem after update remaining for me is gsx level 2 can not recognise the door positions and height which I set under ac settings.
I am using prepar3d v5.3 and prosim's ac model ProSimB738-2022 Pro
This is the only problem remainig after the update.
If you need any file to investigate the problem please tell me I am ready to send.
Best Regards
--- End quote ---
--- Quote from: Aussie123 on August 29, 2022, 01:28:56 am ---Same here. Prosim B737. The door heights are metres out on start up. After modifying them with the 3D editor they stick for that flight. Change and airport location and they are out again.
I run the updater every day and this problem still remains.
Aussie
--- End quote ---
Also same in FSX. I have a gsx.cfg file saved for correct door position for my 757. With the file in the correct folder in AppData\Roaming\Virtuali\Airplanes, GSX does not read it. Deleted and completely set it up again using the editor and, as mentioned above, works only for the current session.
Papacoach:
Experiencing this also on CS767, CS757 but not on PMDG NGXu, 777, 747, QW787, aerosoft 333 so far. Testing the rest of the fleet...
goesto11:
--- Quote from: Papacoach on August 29, 2022, 09:53:42 pm ---Experiencing this also on CS767, CS757 but not on PMDG 777, 747, QW787, aerosoft 333 so far. Testing the rest of the fleet...
--- End quote ---
I will test some others and report back.
goesto11:
Tested CS757, PMDG 737NGX, PMDG 777 and Aerosoft A320 family. Same results for all - if I make changes in the editor, it works fine for that session and it writes the changes to the file. If I then close and reopen the sim, everything is out of position again BUT the gsx.cfg files do not change - they still reflect the changes I made in the previous session. The only way to get it to work is to delete the respective gsx.cfg and start again. Which sets the whole cycle off again. This is in FSX-SE.
Papacoach:
--- Quote from: goesto11 on August 29, 2022, 11:26:58 pm ---Tested CS757, PMDG 737NGX, PMDG 777 and Aerosoft A320 family.
--- End quote ---
Interesting. I had not edited any airplane cfg files in a long time. In my case GSX read most of the aircraft files that had been unchanged for months. All but the CaptainSim addons, which were not read correctly the first time since the update. Then after editing they would only be read the first session like you commented.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version