Products Support > GSX Support FSX/P3D

GSX passenger walk in.

(1/2) > >>

jem:
How do I delete waypoints that are already set for a passenger walk in path? I set a path, but I want to delete it, and start a new path at a gate.
Thanks.

virtuali:
Edit the path, select the last waypoint and press F5 until all waypoints are removed and only the Gate Pax remains, move it ( if you need to move it ) and start adding waypoints with F6

jimr:
I was looking for same info. I get it to work fine pressing F5 to delete then redesigning the walkway whilst in same edit mode but if i have completed the walkway and saved it how do i delete to start again? I have been going into C:\Users\xxxx\AppData\Roaming\Virtuali\GSX and deleting the config file and starting again. Is there another way?
Thanks

virtuali:

--- Quote from: jimr on February 22, 2022, 12:01:03 pm ---I was looking for same info. I get it to work fine pressing F5 to delete then redesigning the walkway whilst in same edit mode but if i have completed the walkway and saved it how do i delete to start again?
--- End quote ---

Was my last explanation not clear enough ?

What do you mean with "start again" ? Start in the same situation as when you first enable the passenger waypoints ? If yes, my reply explained exactly that:

What's your situation when you start, before adding any waypoints ? You see only one thing, the Pax Gate, which you are supposed to move to the terminal door, and then start adding waypoints.

So, by following my previous instructions, if you remove all the existing waypoints with F5, you will end up again in the same initial situation, with only the Pax Gate objects, which is now already on the terminal door but, of course, you can just move it and then add waypoints, move them, etc. No difference.

SN737:
Umberto, would you mind telling me what F5 does in p3d key assignments by default, I deleted it and no longer can make the delete waypoints to work.

Navigation

[0] Message Index

[#] Next page