Products Support > GSX Support FSX/P3D

AKC shows through fuselage

(1/2) > >>

miata54:
See pic. As the AKC container is moving in the cargo bay towards the Commander, part of the container is visible on the outside wall of the fuselage. The Commander is properly positioned. I tried using an AKE but the results were the same. Suggestions please.

Thanks

virtuali:
That's because you are using an AKC container, which is shaped to be used on the lower cargo ( so it would follow the lower fuselage curvature ), on a Main Cargo door, which should use different kind of containers, like A1N, SAA or various Pallets.

You can change which kind of containers each loader will use in the airplane configuration page, in this case you'll have to change the Main Cargo door.

miata54:
The aircraft is the MD11F by Premier Aircraft Design for FSX. I had  success using the container DZH for the lower starboard forward Cargo 1 Door, but no success using the same container for the Main Cargo Door, upper port side fuselage. I tried every container cfg that  GSX lists on the Main Cargo Door, and the DZH was the least offensive. There must be a difference in fuselage width from the PMDG model to PAD model.

virtuali:
DZH is not right for the Main Cargo. Try SAA or A1N, or any of the various Pallets.

Keep in mind that, by selecting the container types with CTRL+Shift from their list, you can select multiple types so, the usual configuration we do for Main Cargo doors are SAA, A1N and all the Palletxx

miata54:
Take a look at these pics. Pics 1 shows DZH container as it moves towards the door, visible through the fuselage. I then tried your suggestion of the A1N container which you can see in pic 2. Clearly visible through the fuselage. Same results with the SAA and all Palletx configurations.

I'm going to see if I can find another MD11F model to see if the fuselage width is different from the PAD model.

Navigation

[0] Message Index

[#] Next page