Products Support > GSX Support FSX/P3D

Just warp up me there function makes A/C heading opposite 180 degree

(1/3) > >>

elphaso:
Hi

I usually use that function GSX but it seems not work properly with P3D V5.3

It only move A/C get to the point with opposite heading A/C

I reinstalled GSX latest version and test over and over with default airport and also 3rd party airport Flytampa, aerosoft etc...

Please check that function

Thanks

virtuali:
There are no problems with that function, which works as it always did, and is still working now.

The heading the airplane is moved to is taken from the scenery AFCAD (or the GSX custom profile, if you changed it there ) so, if it's reversed, it's because it's reversed on that particular parking on that particular scenery.

Sometimes, parking spots are connected to two apron paths linked to the opposite side of the parking spot in the AFCAD so, one of them will be the "wrong" heading but, GSX cannot obviously decide which one to use so, it will use the heading the parking is set in the AFCAD. It has been like this since GSX came out and yes, I checked it now, and is still working normally.

elphaso:
OK...

I will reinstall all of scenery and airport.. 

That's too tough ... but no choice..

hope to find a solution

thanks..  ;)

virtuali:

--- Quote from: elphaso on December 19, 2021, 11:08:43 am ---I will reinstall all of scenery and airport.. 
--- End quote ---

Nowhere I said you should do that. As I've said, this should only occur on a few parking spot on a few sceneries, maybe you only tried a couple of places which incidentally were made that way, and assumed GSX started to read all parking heading backwards ?

elphaso:
I tested many other places and airports

I found that when i use the function the heading of A/C not quite 180 degree.. it seems 160 degree..


anyway, I already remove whole of my sim and scenery

and Now it works fine

Navigation

[0] Message Index

[#] Next page