Products Support > GSX Support FSX/P3D

Teletraps don't work

(1/3) > >>

dron960:
Hello Umberto.
Teletraps don't work. When you press the test key NUM5 GSX shows that the sleeve should work for the output of 1L. This can be seen in the screenshot by the inscription on the green stripe. But when you exit the editor, the sleeve becomes unavailable again, it's strange.
With respect.

Captain Kevin:
I have no idea what teletraps are, so I don't know what the issue is, and your screenshots are far too small to be able to make out what's going on.

dron960:
Well, I do not know what else to call them. Jetways

virtuali:
Your screenshots are still very unclear however, if GSX says there are no jetways there, it's usually because you haven't removed the ones provided with the scenery.

dron960:
I can't take screenshots bigger than that, the site won't let me send them. Initially there were no jetways there. The terminal model is made for GSX. It's just that when you configure jetways in the editor, the test shows that they are available for 1L output. When exiting the editor and calling GSX, it writes No jetways. It was on the screenshots.  Maybe I can send you normal screenshots to any email?

Navigation

[0] Message Index

[#] Next page