Products Support > GSX Support FSX/P3D

GSX 2.9.4 AFCAD issues

<< < (2/3) > >>

Keight:
having the same issue with the latest update. gsx ignores ini files in Virtuali GSX folder and creates new one based on default afcad

virtuali:

--- Quote from: Keight on September 15, 2021, 01:52:14 pm ---having the same issue with the latest update. gsx ignores ini files in Virtuali GSX folder and creates new one based on default afcad
--- End quote ---

Your problem, at least as you describe it, doesn't seem to be GSX loads the wrong AFCAD but ( again, as you described it ), is ignoring the .INI. Is this what you meant ? Is GSX loading the correct AFCAD but it ignores the .INI OR, is also loading the wrong AFCAD too ?

If a default AFCAD is loaded, with the latest update, the .INI is CORRECTLY ignored, as the release notes say:

https://www.fsdreamteam.com/couatl_liveupdate_notes.html


--- Quote ---In P3D V5, if the loaded AFCAD file belongs to the default scenery (name starting with APX*.BGL ), a customization profile that might have been made for FSX or P3D4 won't be loaded, preventing likely mismatches between parking names. In this case, the customization will start from scratch. When saving from P3D V5, the new .INI file will be flagged with "p3d5only = 1" in the [General] section, so other simulators won't load it.
--- End quote ---

So, if the loaded is .BGL is from the default scenery, fact GSX is Ignoring the .INI is absolutely correct and intentional.

But then the issue would be: in YOUR situation, was the default .BGL the correct choice ?

Keight:
not sure I am following. by default acfad I dont mean P3D default airport but 3rd party scenery afcad without my customizations. GSX ignores ini files where afcad path does not contain full path.
Before the update it was not required - for example "afcad_path = AFD_UBBB.bgl" was sufficient. I have too many config files to edit them manually one by one.

virtuali:

--- Quote from: Keight on September 15, 2021, 03:35:47 pm ---not sure I am following.
--- End quote ---

My question was, before saying GSX is ignoring your .INI, have you verified it has loaded your .BGL ? If it hasn't loaded your .BGL, it's normal it won't even try to load its associated .INI

Keight:
I am sorry Umberto it was my mistake, everything working good. I apologise.

Navigation

[0] Message Index

[#] Next page

[*] Previous page