Products Support > GSX Support FSX/P3D
GSX 2.9.4 error after update
Salma:
I'm using vtbs of a_a, but in the previous version 2.9.3, it was loaded normally without errors, but after updating to 2.9.4, the following errors occur.
virtuali:
Assuming you are using P3D5, the problem is your .INI file, which must have been made for P3D V4, using custom textures, because an operator called "SCB" doesn't exists in GSX.
Before the update, this won't cause any problems, because jetway logos were completely disabled but now, since we added multi-liveries back, if an .INI file contains any logos, they MUST be one of the stock logos included with GSX, because in V5 custom textures are not supported.
We are working on an update that will check existing .INI files and will automatically ignore any logos for operators not included by GSX but, in the meantime, the only way to fix it is to edit the file and remove all lines containing
jetway_logo = xxxxxxxx
Unless they contain a name of an operator that does exists in GSX.
Salma:
I see, As I expected, it was a problem with the logo file, but there was no problem with the 2.9.3 version, but is it normal to have such a problem after the 2.9.4 update?
virtuali:
--- Quote from: bjhjeong01 on September 09, 2021, 05:56:25 pm ---I see, As I expected, it was a problem with the logo file, but there was no problem with the 2.9.3 version, but is it normal to have such a problem after the 2.9.4 update?
--- End quote ---
That's precisely what I explained in my previous post, so I'll repeat it again:
Before the update, this won't cause any problems, because jetway logos were completely disabled but now, since we added multi-liveries back, if an .INI file contains any logos, they MUST be one of the stock logos included with GSX, because in V5 custom textures are not supported.
So yes, it's normal and, if you read also the 2nd part of my post, you would know we are working on a way to fix this automatically.
Salma:
I removed all the entry Jetway_logo = xxxxxxxx from the ini file, but there is still an error. What else should I modify?
Navigation
[0] Message Index
[#] Next page
Go to full version