Products Support > GSX Support FSX/P3D
Problem with GSX 2.9.4 | Only works once after LiveUpdate
disco79stu:
--- Quote from: virtuali on September 07, 2021, 02:43:42 pm ---I tried doing something similar to what you did in your video ( calling catering and then "reset position" ), and it works just fine, see the video:
As you can see, I also tried a reset position after calling refueling and even the most tricky one: a reset while SODE jetways were moving, which restarts both SODE and GSX, and that one worked normally as well.
--- End quote ---
Okay, thanks, then it's definitely something messed up on my end.
When I tried to reset with SODE moving, it did not restart SODE.
I'll try a clean re-installation of GSX and SODE.
disco79stu:
Okay, so I uninstalled GSX and AddonManager and re-installed everything.
Unfortunately, the problem persists.
I believe that after the 1st run (after LiveUpdate, where everything works), GSX apparently won't start properly. I didn't notice this at first but let's forget the catering/resetting etc. for a second.
Here's what happens:
- 1st run, everything's OK. In the top menu bar under "Add-ons" I have "Couatl settings", "Couatl Live Update" and "GSX". All good & working.
- Quit P3D normally.
- 2nd run, GSX now unresponsive, in the top menu I now only have "Couatl settings" and "Coutl Live Update". ... "GSX" is missing (as seen in my video as well).
Nothing I do (reboot, restart etc.) will bring the "GSX" menu entry back from this point on. So "something" is not starting anymore after the 1st run, for whatever reason.
Any ideas?
virtuali:
I was fairly sure the problem won't be fixed by reinstalling GSX because, it's most likely not caused by GSX.
I'll ask again: do you see some of the green messages ? Check if you have the GSX Verbosity setting to the maximum value.
disco79stu:
--- Quote from: virtuali on September 07, 2021, 05:11:13 pm ---I was fairly sure the problem won't be fixed by reinstalling GSX because, it's most likely not caused by GSX.
I'll ask again: do you see some of the green messages ? Check if you have the GSX Verbosity setting to the maximum value.
--- End quote ---
Yes, after setting the messages to "all", I saw every message, green and red. The ground handler was mentioned as well as the airport cache etc. Seemed legit.
But still, it doesn't work anymore after I quit P3D with the above mentioned missing "GSX" menu entry.
virtuali:
--- Quote from: disco79stu on September 07, 2021, 05:14:37 pm ---But still, it doesn't work anymore after I quit P3D with the above mentioned missing "GSX" menu entry.
--- End quote ---
Which is not what you showed in the video, which was GSX not restarting during a normal session. Now you are saying it's not starting after you quit P3D ( and I assume after you also restart P3D ) so, are you:
- Still getting the problem of the "reset position", as in your previous video ?
- Getting a different problem, which is a failure to start after quitting and restarting the sim ?
- Getting both problems ?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version