Products Support > GSX Support FSX/P3D
Problem with GSX 2.9.4 | Only works once after LiveUpdate
virtuali:
--- Quote from: disco79stu on September 07, 2021, 02:21:38 pm ---I have that enabled, yes
--- End quote ---
Are you sure ? Then why I can't see the green message saying ( in your case ) "[GSX] Handling by Menzies" and "[GSX] Catering services requested" appearing in sequence in your video ?
--- Quote ---I see this message when I open the Sim after LiveUpdate. I've never seen that oon position reset before though, only when "restarting and rebuilding airport cache".
--- End quote ---
That's a problem indeed but, as I've said, it's strange you don't have the following two messages:
"[GSX] Position Reset" appearing for a very short time as soon as you select "Reset position" ( this might be too brief to be seen, some times )
"Airport cache loaded successfully" when the restart completed. This, coupled with the fact you don't have the "Handling" and "Catering" messages too, seemed to indicate either you have disable all green messages altogether, or there's a problem with those menus.
disco79stu:
It's getting a little confusing to me.
I get some messages, yes, but not all, so maybe I indeed deactivated them and only get the important ones?
Anyway, I'm a little step further now:
I tested several combinations, and everything worked as usual. Repositioning the aircraft, calling stairs, restarting couatl, everything fine.
UNTIL I call for catering. Then and only then I will have an entry in the pop-up menu to "reset position" (not "reposition aircraft"). When I hit THAT, GSX breaks.
Will keep testing....
virtuali:
--- Quote from: disco79stu on September 07, 2021, 02:33:02 pm ---UNTIL I call for catering. Then and only then I will have an entry in the pop-up menu to "reset position" (not "reposition aircraft"). When I hit THAT, GSX breaks.
--- End quote ---
That's not normal either. The "Reset position" will appear after you start ANY service, not just Catering. And it won't replace the "Reposition aircraft" at the 0 slot but, instead, will replace the "customize this parking position" at slot 9, because you can't customize a parking while services are running.
disco79stu:
--- Quote from: virtuali on September 07, 2021, 02:39:46 pm ---
--- Quote from: disco79stu on September 07, 2021, 02:33:02 pm ---UNTIL I call for catering. Then and only then I will have an entry in the pop-up menu to "reset position" (not "reposition aircraft"). When I hit THAT, GSX breaks.
--- End quote ---
That's not normal either. The "Reset position" will appear after you start ANY service, not just Catering. And it won't replace the "Reposition aircraft" at the 0 slot but, instead, will replace the "customize this parking position" at slot 9, because you can't customize a parking while services are running.
--- End quote ---
Okay, so I guess I should completely de- and re-install then. Maybe this helps.
virtuali:
I tried doing something similar to what you did in your video ( calling catering and then "reset position" ), and it works just fine, see the video:
As you can see, I also tried a reset position after calling refueling and even the most tricky one: a reset while SODE jetways were moving, which restarts both SODE and GSX, and that one worked normally as well.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version