Products Support > GSX Support FSX/P3D

GSX Level1 How to remove the original ground paint around the jetway.

(1/2) > >>

Abraxas:
GSX Ground Service Level1 2.8.3 P3D v5.2 .22.27615
I have created some sceneries with ADE. When P3d starts GSX replaces the jetways from the AddonScenery with the jetways from GSX. However, the ground paintings belonging to the jetways from the Addon Scenery are still visible and additionally the ground paintings of the GSX jetways are also shown. I have through GSX now twice the ground painting around the jetway. My question how to remove one of the two shown ground paintings?
Thanks Abraxas

virtuali:
The default jetways replacement model it's designed to replace the default jetway so, it has the same dimensions, it comes with a bridge of the same size of the default one which you cannot change or remove, and it comes with ground markings like the default jetway model which you cannot change or remove.

All the other 85+ jetway models, have selectable bridges and ground markings that can be optionally disabled.

Abraxas:
Thanks for the quick reply. I am a bit helpless, because in the addon sceneries only the default jetway model with GUID bfcdf52b-9142-415c-8318-03c1b92ca9d9 was used.
As you can see on the picture, the jetway itself was replaced, the ground painting was not.
What do I have to do so that only one ground painting can be seen?
Thanks again Abraxas

virtuali:

--- Quote from: Abraxas on August 31, 2021, 05:16:02 pm ---Thanks for the quick reply. I am a bit helpless, because in the addon sceneries only the default jetway model with GUID bfcdf52b-9142-415c-8318-03c1b92ca9d9 was used.
--- End quote ---

If you mean you have an add-on scenery using the default jetway AND additional own ground markings in the airport background textures, then it would have the same exact problem of double markings, regardless of GSX because the default jetway model DOES have ground markings which cannot be disabled.

But again, the whole point of GSX customization, is that you can CHANGE the jetway model, once they have been replaced with GSX and, as I've said, all other jetway models in GSX DO have the option to disable the ground marking.

Abraxas:
No, the shown addon scenery uses the standard jetways without additional ground markings or additional ground polygons.
Where can I read how the jetways or the ground markings are changed in the GSX customization?
Thanks again Abraxas

Navigation

[0] Message Index

[#] Next page