Products Support > GSX Support FSX/P3D

Problems with GSX Customization

(1/3) > >>

Jammin16:
Hi,
I have a problem I can't use GSX Customization, if I would use it there open an error code/ message as you can see on my pictures.

Hope some can help me

Best
Jammin16

Pictrues:
https://ibb.co/cwWssDS
https://ibb.co/wwT9fwR
https://ibb.co/9t4pNDn

virtuali:
Please clarify if this happens with this airport, or everywhere else. Also, which kind of jetways does the airport comes with ? I see you checked the "don't create jetways" option, is this what you intended to do ?

Jammin16:

--- Quote from: virtuali on July 15, 2021, 02:05:02 pm ---Please clarify if this happens with this airport, or everywhere else. Also, which kind of jetways does the airport comes with ? I see you checked the "don't create jetways" option, is this what you intended to do ?

--- End quote ---

Hi, The idea of using GSX Customization was that I want to change a bit where the plane should stop so that I keep more precise in relation to the jetway.  I have used this before to change some locations of the GS and the aircraft itself. Wellington International Airport from Flightbeam studios have made perfect jetways and they are controlled by SODE. I don't want to change the jetkways.

I have tried this option on an other airport and I didn't have the same problem.

Jammin16

virtuali:
Then you must have made some kind of mistake, because it seems you tried to replace the jetways with GSX, then you probably set the "don't create jetways" option, which is not used to undo a replacement gone wrong.

If you just want to change your stop position, there's no need to touch or replace the jetways, just adjust the stop position. I think it's best if you remove your custom profile and start from scratch. GSX should tell you the scenery has SODE XML jetways.

Jammin16:

--- Quote from: virtuali on July 16, 2021, 01:39:49 pm ---Then you must have made some kind of mistake, because it seems you tried to replace the jetways with GSX, then you probably set the "don't create jetways" option, which is not used to undo a replacement gone wrong.

If you just want to change your stop position, there's no need to touch or replace the jetways, just adjust the stop position. I think it's best if you remove your custom profile and start from scratch. GSX should tell you the scenery has SODE XML jetways.

--- End quote ---

Yeah  something went wrong, I know how to change position, but I don't know why it will change jetways?

How can I make it not change jet paths?


Should I reinstall the airport?

Navigation

[0] Message Index

[#] Next page