Products Support > GSX Support FSX/P3D

No AFCAD

(1/1)

barrykensett:
I have been using GSX for some time with P3Dv4.
I have upgraded to P3Dv5 and reloaded GSX. All appeared normal and registration was accepted.
When I try to start with Ctrl+F12 i get an error message that no AFCAD exists for this location.
I get the same wherever I load it.
Can you advise please.
Barry

virtuali:
Try "Restart and rebuild the airport cache" from the Couatl Settings menu, and pay attention of the airport cache is created, so you'll see an "airport cache loaded" at the end.

If the process doesn't start, or seems very long, it might be caused by the antivirus so configure the antivirus to add the following folders to the antivirus Exclusions:

- The main Addon Manager folder, where GSX is installed

- The main P3D installation folder

Then try again the cache rebuild

Navigation

[0] Message Index