Products Support > GSX Support FSX/P3D

GSX failing to recognise Engines have started in FSLabs

<< < (2/2)

virtuali:

--- Quote ---It then asks to confirm good engine start.  When I open the GSX dialogue it states Engine not started.
--- End quote ---

Which is why I said, if this happens, you can select the OTHER option (other than Abort), which is "Stop here and complete pushback procedure", which will result in completing the procedure and ignoring the engines.

lchannell:
Sorry,


--- Quote ---the OTHER option (other than Abort), which is "Stop here and complete pushback procedure",
--- End quote ---

Perhaps I am not being clear - I did inform you that the OTHER (as you suggest) option did not resolve it either.


--- Quote ---Quote from: lchannell on April 30, 2021, 01:38:06 PM
The Stop Here and Complete PB function creates the same problem, I have tried this and the Abort function over and over.
--- End quote ---

For clarity:

1.   Selecting Abort DID NOT resolve the problem
2.   Selecting Stop here and Complete pushback DID NOT resolved the problem

I had tried both of these options at least three times each.  My only solution was the reinstall, which fixed it, as I have stated.

Thank you.

virtuali:

--- Quote from: lchannell on May 04, 2021, 02:29:59 pm --- had tried both of these options at least three times each.  My only solution was the reinstall, which fixed it, as I have stated.
--- End quote ---

Then it IS working now ?

If yes, it wasn't reinstall that fixed it, since nothing in it could possibly have anything to do with a reinstall. It might simply be you had an old version, so it would have been enough to run the Updater, with no need to reinstall.

Of course, reinstalling would be the same, because the installer does exactly that: it runs the updater at the end.

Navigation

[0] Message Index

[*] Previous page