Developer's Backdoor > GSX Backdoor

Time until GPU arrives

<< < (2/4) > >>

torsten:
ok, so what do you mean with "close to the Airplane" and how long should it take tuntil the GPU is there ?

I have one additional Question.
At some Airports i have the "normal SODE" Jetways.
Sometimes, if you forget to operate the Jetways BEFORE you request Deboarding, GSX shows a Message, something like "Remember to operate the Jetways".
But when i after that try to operate the Jetways via GSX, it is not working. ( before requesting the Boarding/Debording it works )

Can this be changed ? ( so that it is also possible to operate the Jetways AFTER requesting the debording/boarding )

Ps.: in GCLP it takes 3 min until GPU arrives

virtuali:

--- Quote from: torsten on April 10, 2021, 07:20:30 pm ---ok, so what do you mean with "close to the Airplane" and how long should it take tuntil the GPU is there ?
--- End quote ---

Close means close, like 50 meters at most.

torsten:
ok, then it much far away comming from :-)
...and as above ... the GPU needs around 3 mins ...

virtuali:
- Please indicate the precise, exact, sequence of the operations you made in GSX.

- Check if this happens only when landing on a new airport after having used GSX on departure.

- Check if this is fixed by choosing "Restart Couatl" as soon after you land.

torsten:
Ok, i had the Time to check that all:


--- Quote ---- Please indicate the precise, exact, sequence of the operations you made in GSX.

--- End quote ---

I test it in different ways:
1. i start P3D, after all is loaded, i call the GSX Menü and directly the GPU
2. i start P3D, after all is loaded, i select another Airport, and then the GSX Menu and then the GPU ... the same Result as in 1.
3. i start P3D, after all is loaded i made a small flight without using GSX from EDDP -> EDDC, and call then GSX and the GPU ... the same Result as in 1.
4. i start P3D, after all is loaded i made a small flight , call GSX for Pushback and then i few EDDP -> EDDC, and call then GSX and the GPU ... the same Result as in 1.

Then i tried No. 2 and 3 with restarting Couatl after landing...also the same Result...sorry


----------------

Can you say something about this :

--- Quote ---I have one additional Question.
At some Airports i have the "normal SODE" Jetways.
Sometimes, if you forget to operate the Jetways BEFORE you request Deboarding, GSX shows a Message, something like "Remember to operate the Jetways".
But when i after that try to operate the Jetways via GSX, it is not working. ( before requesting the Boarding/Debording it works )

--- End quote ---

Navigation

[0] Message Index

[#] Next page

[*] Previous page