Products Support > GSX Support FSX/P3D

FlyTampa Amsterdam/GSX

(1/2) > >>

devd:
Hello everyone, I have FlyTampa Amsterdam and GSX 1&2, unfortunately when I hit operate jetways (default flytampa) it doesn’t give me the option to choose which jetway to which door which leads me to the main problem. it has 2 bridges but it only shows one on the airport positions.

Thank you all

virtuali:
Please clarify which jetway ( standard, SODE or GSX ) the scenery is using.

devd:
The jetway is the standard (One that came with the scenery)

virtuali:

--- Quote from: devd on February 20, 2021, 01:30:19 pm ---The jetway is the standard (One that came with the scenery)
--- End quote ---

Meaning it works with CTRL+J ? In that case, it's entirely normal you won't see any menu about which jetway and which door to use: standard jetway system only supports one jetway per gate, and it will always dock on the main passenger exit.

That's the whole point of using SODE jetways, and that's the whole point of GSX allowing to replace standard jetways on scenery that didn't come with those but, as clearly explained on the manual, GSX doesn't automatically replace standard jetway at 3rd party airports, the only standard jetways replaced by GSX automatically, are the default model used on default airports.

This very section of the forum has two tutorials on how you replace jetways on a 3rd party airport.

devd:
I tried that, I’m at gate F6 (which has 2 bridges)whenever I select the menu or hit ctrl+j only 1 jet bridge moves, I’m not sure if that has something to do with GSX or if it’s a flytampa issue

Navigation

[0] Message Index

[#] Next page