Products Support > GSX Support FSX/P3D
GSX2 No Jetways Here ...
virtuali:
--- Quote from: trisho0 on February 26, 2021, 05:02:01 am ---I apologize so sorry about this. I am trying to say "didn't work" I meant the jetways didn't go to dock doors regardless if the exclusion Z41 is added or not in CouatlAddons.INI file. I know GSX identified PANC but still "No Jetways Here".
--- End quote ---
The exclusion is required to let GSX know you are at PANC, so that's working,.
If GSX reports no jetway, as explained already, it's likely because a problem with that scenery XML file, that don't match the gate names in the AFCAD.
trisho0:
Umberto, I don't know how to figure the scenery XML not matched gates names in the AFCAD.
virtuali:
--- Quote from: trisho0 on February 28, 2021, 06:00:21 pm ---Umberto, I don't know how to figure the scenery XML not matched gates names in the AFCAD.
--- End quote ---
I think I already explained it earlier in this thread.
Captain Kevin:
Just investigate this, and it works fine on my end. Just to confirm, is your SCENERY up to date. I only ask because in a previous post, you mentioned having to remove these two files:
PANCjetways.BGL
PANCjetwaysteil2.BGL
Looking at my scenery folder, those files don't exist.
trisho0:
--- Quote from: Captain Kevin on March 01, 2021, 01:19:54 pm ---Just investigate this, and it works fine on my end. Just to confirm, is your SCENERY up to date. I only ask because in a previous post, you mentioned having to remove these two files:
PANCjetways.BGL
PANCjetwaysteil2.BGL
Looking at my scenery folder, those files don't exist.
--- End quote ---
Hello Captain Kevin, You are looking at your P3D sim instead of FSX? My question is for the FSX sim only. P3D works just fine with jetways.
Patricio
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version