Products Support > GSX Support FSX/P3D
Missing Addon Manager menu After Recent UPDATE **SOLVED**
19pecker67:
Thank you for your swift response.
Please find attached the zipped log file.
Andreas
virtuali:
Are you sure you called GSX before exiting ? The log doesn't show that.
19pecker67:
Ok, I try again:
1. Starting p3d.
2. Restart Couatl: Green: Airport Cache loaded successfully.
3. Ctrl-F12: Red: No valid AFCAD...
4. Disable GSX: Green: Airport Cache loaded successfully.
5. Enable GSX: Green: Airport Cache loaded successfully.
6. Ctrl-F12: Red: No valid AFCAD...
7. Shift-Ctrl-F12: Red: No valid AFCAD...
8. Exit p3d.
9. zipped Couatl.log and sent to you. 11:10UTC
paulinyyz:
In my case the following message occurs at all airports, regardless of developer; [GSX] Could not find valid AFCAD data at this position, services are not available
The missing terminal buildings and jetways are/is occurring at only FSDT airports. Not all buildings and jetways are missing, you can be sitting at a gate which looks fine and then look 180 degrees and find that the terminal and jetways behind are missing but the light standards may be there.
I checked to see if I have Microsoft Visual C++ 2015, both 32-bit and 64-bit and they are both installed.
I am also missing the Couatl menu where you register FSDT products.
I have also tried to generate a log but when I check the box and click on apply and then Ok, the check mark disappears.
Paul
virtuali:
--- Quote from: paulinyyz on September 15, 2020, 01:50:07 pm ---I am also missing the Couatl menu where you register FSDT products.
--- End quote ---
The Couatl menu is not where you register the products. That would be the Addon Manager menu.
Check if the Couatl menu initially is there, and then it disappears, which indicates it has crashed on start for some reason, but it started, otherwise you wouldn't have seen the "Could not find valid AFCAD data" message.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version