Products Support > GSX Support FSX/P3D

USING embedded stairs option

<< < (2/4) > >>

Butch:
I reset the aircraft config and use the pax1 with no embedding and you can see results in my shots.

Notice as the passengers descend halfway down the ladder they turn around and face the door then when the are on the tarmac they face the bus and walk towards it.

At least they didn't drop to the tarmac and then climb back into the aircraft then exit down the stairs.





 

Captain Kevin:
I assume when he asked for a screenshot of the door, he meant in the GSX editor to tell GSX where the door is supposed to be, much like you did for the top and bottom of the stairs.

Butch:

--- Quote from: Captain Kevin on September 12, 2020, 10:26:57 am ---I assume when he asked for a screenshot of the door, he meant in the GSX editor to tell GSX where the door is supposed to be, much like you did for the top and bottom of the stairs.

--- End quote ---

THis is about the only other shot I can think of that is needed otherwise....I'm confused.

Captain Kevin:
And if you click Customize in 3D Editor, what do you get.

Butch:

--- Quote from: Captain Kevin on September 12, 2020, 03:21:47 pm ---And if you click Customize in 3D Editor, what do you get.

--- End quote ---

Navigation

[0] Message Index

[#] Next page

[*] Previous page