Products Support > GSX Support FSX/P3D

P3C passenger drop

(1/2) > >>

Butch:
I recently was able to embed a stairway for the L-188 and so I am now trying to do the same for the KBT-P3C. I know how to embed the stair and adjust the "X" "Y" axis so as to
position where the star (Ladder) is located so GSX know where the pax are to board/deboard. As a result, the deboard process is less then steller.
As you can see in my photos, the passengers are dropped from the aircraft and never use the stairs. To watch the animation, the passengers look confuse as to not know
where to egress. I am at the KMEM airport.  I use P3D V4.5

I've tried to relocate the X/Y axis at the base of the ladder and that did not render the passengers using the stairs, They just drop directly below the aircraft near the stair and walk from
there towards the waiting bus.  Any suggestions would be most appreciated.  Thanks
https://i.postimg.cc/prk8rCYV/P3-1.jpg

https://i.postimg.cc/XNg9sNSM/P3-2.jpg


https://i.postimg.cc/NjKTG1yY/P3-3.jpg

virtuali:
The problem is that you moved the door on the ground, which is not what you are supposed to do and will of course confuse GSX.

The door should stay at its correct place, but you should set the start and end points for the Embedded Stair, as explained at Page 54 of the manual.

Butch:
I did look at your page 54 and I do not get any start/end options. Just one for the Pax 1 placement. See photo.

https://i.postimg.cc/wv1yb5L7/GSX.jpg


https://i.postimg.cc/7PMwrG96/Pax.jpg

virtuali:

--- Quote from: Butch on September 10, 2020, 04:25:40 pm ---I did look at your page 54 and I do not get any start/end options. Just one for the Pax 1 placement.
--- End quote ---

Assuming you have checked the box labeled "Embedded Stair", the Start/End point will appear by cycling doors, as if they were additional doors.

Butch:

--- Quote from: virtuali on September 10, 2020, 04:28:11 pm ---
Assuming you have checked the box labeled "Embedded Stair", the Start/End point will appear by cycling doors, as if they were additional doors.

--- End quote ---

I do thank you for your help and you patience. I did use the "embedded stair" and from there all I see is the X/Y lines that I can set the location of the stars.

Could you please digest that cycling doors comment - I assume you mean to open/close the ladder. The door opens then another shift E + 2 key for the ladder to swing out.

I cannot do that during the placement of the stairs in GSX aircraft config mode. I read and reread the Page 54 instruction on this hoping that I'll better understand what to do to

get this start/stop functions to work for me. Having no luck getting the start/stop to function, I just raised the location of the ladder point to level with the cabin floor of the plane.

This resulted in the Passengers at least leaving the plane from where the door is but turning around and going down the ladder facing the plane.

BTW - I use both P3D V3.4 AND P3d V4.5 and the gsx program is using the 32 bit version - thought I'd have to use both the 32 and 64 bit versions. What is you take on that?

Thank you

https://i.postimg.cc/yN9Jch4K/PAX5.jpg


I might add that after I used embedded stairs the next step is customized in 3D editor the screen goes to slew and no ladders can be opened/closed.

Navigation

[0] Message Index

[#] Next page