Products Support > GSX Support FSX/P3D

Passengers are shown outside the jetway

(1/2) > >>

alpet:
Hi there,

Please see the attached image - is it something which should be addressed to scenery developers? Or can I do something here manually?

This is Keflavik BIKF by MK Studios.

virtuali:

--- Quote from: alpet on May 29, 2020, 05:14:40 pm ---Please see the attached image - is it something which should be addressed to scenery developers? Or can I do something here manually?
--- End quote ---

it's possible some SODE parameters for that jetway are not precise enough, difficult to say without looking at it. I guess it doesn't happen with GSX jetways ?

alpet:

--- Quote from: virtuali on May 31, 2020, 04:56:40 pm ---
--- Quote from: alpet on May 29, 2020, 05:14:40 pm ---Please see the attached image - is it something which should be addressed to scenery developers? Or can I do something here manually?
--- End quote ---

it's possible some SODE parameters for that jetway are not precise enough, difficult to say without looking at it. I guess it doesn't happen with GSX jetways ?

--- End quote ---
Yes, I did not see anything similar with GSX jetways but these SODE jetways are provided with the scenery.

virtuali:

--- Quote from: alpet on June 04, 2020, 08:59:48 pm ---Yes, I did not see anything similar with GSX jetways but these SODE jetways are provided with the scenery.

--- End quote ---

There's not much we can do if a 3rd party SODE jetway doesn't have its dimensions exactly right. Yes, if the jetway is long, even a very small mistake can be visible at the end of the jetway.

Report back if you find a similar problem with a GSX L2 jetway, and we'll surely have a look at it.

Airmaz1:
I would be good if it was possible to disable passengers in the parking editor, so if you get this kind of problem with a third party jet way they can be turned off.

I would personally prefer to see no pax instead of this if a particular third party jetway peforms badly.

Navigation

[0] Message Index

[#] Next page