Products Support > GSX Support FSX/P3D

Aerosoft Trondheim with MaddogX: P3Dv4, GSX

<< < (3/4) > >>

Jetzuri:
Please feel free to tell me what I should be asking Leonardo.

I have noticed this at other airports in the past but it didn't bother me, I assumed it was part of GSX as a taster of what GSX Level 2 can do. I'm afraid I don't recall which of my add-on airports it was.

virtuali:

--- Quote from: Jetzuri on June 02, 2020, 01:22:00 pm ---Please feel free to tell me what I should be asking Leonardo.
--- End quote ---

hat I said in my previous post, if the airplane controls the number of passengers on board. But that's besides the point, you shouldn't see any passenger if you don't have GSX L2 active.


--- Quote ---I have noticed this at other airports in the past but it didn't bother me, I assumed it was part of GSX as a taster of what GSX Level 2 can do. I'm afraid I don't recall which of my add-on airports it was.
--- End quote ---

Then report back if it happens on another airport and, most importantly, clearly indicate which kind of jetways ( standard, SODE or GSX/SODE ) that airport has.

Jetzuri:
Thanks, will do, and please let me know when you find a way to remove the pax completely.

If the airport has SODE jetways and I have GSX, isn't the only option SODE/GSX in all cases?

Airmaz1:
Hello.

I've seen this same problem with those Jetways at trondheim, it's because GSX reads the jetway height at a set point and uses it as the spawn location for the pax, but with those jetways they lower their height for low slung aircraft.

With this action it lowers the entire jetway but not the spawn point for GSX.

Jetzuri:
Makes sense, thanks. I wouldn't have noticed had I not had the pax I shouldn't have, so I suppose the easy solution is to remove them.

One way I've found to remove them is to uninstall GSX.

Navigation

[0] Message Index

[#] Next page

[*] Previous page