Products Support > GSX Support FSX/P3D
Floating P3Dv5 jetways at some locations.
virtuali:
--- Quote from: srcooke on May 07, 2020, 08:12:03 am --- but the majority are floating until the altitude is reset in the airport customization.
--- End quote ---
But that's precisely what you are supposed to do to fix those altitude conflicts caused by different sceneries in conflict setting different altitudes. Of course, if you Apply, it will saved for the next time in your custom GSX .INI profile.
srcooke:
--- Quote from: virtuali on May 07, 2020, 02:28:33 pm ---Of course, if you Apply, it will saved for the next time in your custom GSX .INI profile.
--- End quote ---
There is no change in the gsx .ini file as the entry is exactly the same at 233.78 ( 233.780 in the customization tool ) for the LIMC file as attached above.
On next load the jetways are in the air despite the .ini entry except for the odd one or two again as per the image above.
srcooke:
I have loaded the P3Dv4 file ADEP4 afcad and everything works perfectly ok.
Using the supplied ADEV5 format appears to cause the issue, EDDB is also ADEV5
virtuali:
--- Quote from: srcooke on May 07, 2020, 02:56:14 pm ---Using the supplied ADEV5 format appears to cause the issue, EDDB is also ADEV5
--- End quote ---
GSX surely supports the P3D V5 .BGL format, otherwise it wouldn't be able to open default airports. But as I've said, if you said the issue is fixed by clicking the airplane icon on the Ground elevation tab, then how's supposed to work, when there's an altitude conflict.
srcooke:
There is an obvious issue with the ADEV5 file supplied by different developers for LIMC, EDDB, GCLP and published by Aerosoft .
ALL of these airports have floating jetways.
Using the adjust elevation tool DOES NOT fix the issue, it temporarily brings the jetway to ground level until the scenery is loaded next time.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version