Products Support > GSX Support FSX/P3D

Floating P3Dv5 jetways at some locations.

<< < (4/9) > >>

alpha117:
Totally agree, but the question remains
233.78 =  jetways incorrect
233.780 = jetways correct

Also why does GSX not write the correct elevation to the ini

virtuali:

--- Quote from: alpha117 on May 08, 2020, 06:52:22 pm ---Also why does GSX not write the correct elevation to the ini
--- End quote ---

GSX DOES write the correct elevation in the .INI, because under any possible definition, 233.78 and 233.780 ARE exactly the same number and, even by truncating the last decimal, the maximum error would be 1 cm, which cannot justify so big visual difference.

airbadger:
So does anyone have a reliable way to fix this? At Aerosoft's PANC, I'll click the icon to adjust the elevation and it brings the jetways down to the ground. But if I come back (e.g. fly away and return and the jetways reload), the jetways are floating again.

srcooke:

--- Quote from: airbadger on May 24, 2020, 01:08:43 am ---So does anyone have a reliable way to fix this? At Aerosoft's PANC, I'll click the icon to adjust the elevation and it brings the jetways down to the ground. But if I come back (e.g. fly away and return and the jetways reload), the jetways are floating again.

--- End quote ---

Currently my workaround is to use previous v4 afcad where possible.

Hopefully the issue will be identified.

srcooke:
Is this yet an identified issue with some afcad formats Umberto ?

Navigation

[0] Message Index

[#] Next page

[*] Previous page