General Category > Unofficial F/A-18 Acceleration Pack board
NEW Realistic HUD for the Hornet
sonofabeech:
Are Sludge and Neutrino a couple now?? ;D
man you guys are taking this multi bonding a bit too far eh? :P
Sludge:
Damn Sonofa...
Bonding?? First Titanic, now this...??!! hahaha Am I the "good half" or the "bad half"?
sonofabeech:
Ill leave that up to the two of you to sort out lol
Tregarth:
--- Quote ---Instead of using ILS (It should work, but don't quote me on it), press the TCN button directly to the left of the ILS button and input 5-7. That will set the tacan channel to 57X, and X is the default channel.
--- End quote ---
In my cockpit I found the follwing procedure was required
1. Click the TCN button
2. Press 5-7-X Enter
To make the X work click the button between the "9" and the X. If it has been selected properly a green : (colon) wil show.
3. The data bar shows OF 57
4. If a carrier has been placed then the TCN distance data block and ILS bars show.
You would not believe how long it has taken me to sort out problems with AICarriers (Java would not install properly) and this UFC panel so I can write this simple piece of information.
Tregarth:
Dear Sludge and Neutrino,
Sorry, I did not mean to start any rumours with my post! :) ;) :-[
Can the F-18 HUD be transferred into Dino Cattaneo's T-45 Goshawk?
If this were to be so then we could fly from a shore base (Pensacola) then, using AICarriers find the Nimitz and fly the ILS to the deck - a truly useful training mission.
This HUD set up is too good to be confined to just 1 aeroplane.
Thank you,
Tregarth.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version