Products Support > GSX Support FSX/P3D

Editing Sim.cfg conditions

<< < (2/3) > >>

virtuali:

--- Quote from: QFA1213 on April 05, 2020, 04:05:01 am ---Sorry I should have used a better angle. The front were CDS however the rear were TLD. This is also what I get without editing the conditions.
--- End quote ---

It's normal you would get both stairs without editing the conditions, because the default conditions we set allow to see them BOTH on planes like 737 or A320.

The whole point of the thread you linked was the user did not want to see the TLD stairs on those, so I assumed you HAVE modified the file, otherwise why posting your modifications in your previous post ?

Assuming you changed the conditions as you posted in your previous post, check the height of the rear door, which is higher than the front one, so 3.90 might not be enough as a cutoff point.

QFA1213:
CDS
condition = ( %(exitAlt)f >= 1.80 ) and ( %(exitAlt)f <= 4.90 ) and ( %(isCargo)f == False ) and ( %(isCargoStand)f == False )

TLD_ABS-580
condition = ( %(exitAlt)f >= 4.90 ) and ( %(exitAlt)f <= 5.38 ) and ( %(isCargo)f == False ) and ( %(isCargoStand)f == False )

TLD_ABS-1740
condition = ( %(exitAlt)f >= 4.90 ) and ( %(exitAlt)f < 6.40 ) and ( %(isCargo)f == False ) and ( %(isCargoStand)f == False )

Same result. Also included is window showing the default aircraft profile and door height.



So we are both on the same page, my issue is that I don't believe the condition line in the sim.cfg is the only factor determining the vehicle selected. The request in the other thread (CDS only for narrow bodies) is just a simple scenario I'm using to confirm the behaviour because if that doesn't work I can't see anything else working.

QFA1213:
Hi Umberto,

Any suggestions? I've been out of the sim for a few weeks. I've installed the latest update and re-entered the conditions in the post above.

I'm still only receiving TLD stairs at the rear and either CDS or TLD at front despite the conditions suggesting that only CDS should appear.

virtuali:
When you change anything that is related to a Simobject, you must select "Restart and recreate the airport cache" before you can see any changes.

QFA1213:
In this case the changes were made while the sim was shut down.

Navigation

[0] Message Index

[#] Next page

[*] Previous page