General Category > Unofficial F/A-18 Acceleration Pack board

TACAN

(1/2) > >>

Pop:
 I was flying on the CVA off CA( in mp) and noticed that the CVA had a VOR freq listed 117.95(on map). I attempted to tune, but got an error. Checked the MFD -TCN and it had a CH # of 127, still no joy.  Today I flew the T45 and could tune in the TCN and get good neddles.  Looked at the CFG of both and say diff in the "radios" , chnaged the FA18 to the T45, but still no tune(ERROR). Then I checked the Panel and noticed a diff in the "windows gauges window 1 radios", changed that still not able to tune the ch 127 or 117.95???
Wher is that data set???
PS attempting to shoot a TAC approach, the CVA and the TAC do not appear to be in thesame location???
Pop

Pop:
lots of reads! No comments???

Razgriz:
TACAN is not simulated in the FSX Hornet.

Pop:
from the "book"
To set a VOR frequency of 110.5 via TACAN, look at the chart in the appendix for a list of TACAN
channel frequencies. You will see that 110.50 equals a TACAN channel of ‘42X’. Begin by setting the
UFC in TCN mode. Press 4-2-ENTER on the UFC keypad and then select ‘X’ by pressing the little
button to the left of the ‘X’ display. It should become active with a ‘ : ’ symbol.
If you want to set the VOR frequency of 110.5 manually, just press 1-1-0-5-0-ENTER and it will
automatically translate the frequency into the appropriate TACAN channel if you enter a
recognized frequency. If you are having difficulty, try entering 5 full digits instead of 3 or 4.
To set course, you need to use the CRS knob close to the Fuel indicator in the lower left of the
cockpit. It can be scrolled with the mouse wheel. To check the CRS, open the HSI screen on one of
the displays and look at the CRS readout.
   I use it all the time!!!
 ???

Pop:
Am I correct?  what about the Ch#'3/freq thing??? POP

Navigation

[0] Message Index

[#] Next page