General Category > Unofficial F/A-18 Acceleration Pack board
TACAN/ILS
oldpop:
locked ILS bars. they just sit there?????
jimi08:
I'll take a look once I get home from travels...
oldpop:
Jim . any progress on ILS?
PhantomTweak:
Hi, oldprop :)
A few questions, if I may...
Are you within +/- about 10-15° of the runway centerline? And about 4000' AGL, and about 5 NMI of the touchdown point the ILS would guide you to before you expect to see the bars become active?
Are you certain the airport actually has an ILS on the runway you want to use?
Have you tried installing a more updated version? A V18.something?
I don't believe the v17 series are able to install into P3D v4.anything, but I could be wrong. I think it works in P3Dv3 and FSX only. Check the folder named EXTRAS once the plane is installed. Is there a folder in it named P3D Specific Files? If so, did you follow the directions on where to place the files from it to make the plane P3Dv4 compatible? The key file is the HornetFCS.dll file. You should have one showing a size of 111 kb, not the 79 kb of the 32 bit file.
It's the whole 64 bit/32 bit problem. I don't believe the v17 series planes have the 64 bit files needed to work in P3Dv4 and up. Again, though, I may well be wrong.
I'm running FSX:SE, and I had no trouble with the v17 series plane ILS system. I don't have a copy of any P3D version, so I can't be too specific about it all.
I know some of these questions may sound...ummm...kinda dumb....but sometimes it's the simple, silly things that cause the biggest problems.
I hope something in all my babbling is of some help...
Pat☺
oldpop:
downloaded v18 and installed. There was not "extra" folder. I did fine 2 "HornetFCS.dll" files( see below) ILS still "locked" with LOC/GS cross centered!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version