General Category > Unofficial F/A-18 Acceleration Pack board
Autopilot and Radio explainations
PVI_Eagle:
--- Quote from: Razgriz on September 06, 2008, 02:50:14 am ---I still don't get how to set my NAV radio. I went into my ILS page on the pad, set my MFD to ILS, typed in my code but no needles. Can we get a picture or some easier instructions??
Edit:
My NAV1 radio, if I type in 1-0-9-3, it goes to 109.29.. :S
I tried 1-0-9-3-1 and it goes to 109.34...
--- End quote ---
I have the same problem...........
PVI_Eagle
Pop:
may have missed it, but see my post on "tacan" below. Any ideas??? POP
Pop:
To get the "needles" on the MFD u must select "CSEL" on the MFD. Then below the "bingo" switch (just above left knee) -2 switchs cus and hdg. they will allow uto set the heading bug and the cus line!
neutrino:
The FSX Hornet has only one NAV radio, so you can select only one frequency at any one time and depending on the station you are receiving from you can be in either VOR or ILS mode.
But my question is - does the real Hornet has only one NAV radio, because I've seen on its HUD both ILS needles and steering arrow and dots?
Pop:
Strange problem! I have several missions with the F18 “saved”. When I load some of the missions the A/C come in with the AutoThrottle on, which make the a/c scoot across the landscape till I can get the brake on and turn it off. Other missions are OK.
Have ensured the AT is off and “resaved” the mission, but to no avail? Suggestions?
???
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version