Products Support > GSX Sharing area - Scenery Configs

KBOS - BOSTON LOGAN - GSX Level 2. Fully finnished configuration available here

<< < (2/4) > >>

cartayna:

--- Quote from: Railfan0311 on February 14, 2019, 12:25:28 am ---Hello cartayna,

Thank you for the great work!
At FlyTampa KBOS I just can not get it.

I did all three steps exactly but I do not have the new jetways. When I restart Coautl I can see the new Jetways for a very short time.
Do I have to rename a file with the extension "BGL" to "off"?

Maybe I'm doing something wrong.?

Can you possibly help me?

Hello Norman,

You say you can see the GSX2 jetways only for a short period of time and then they dissapear?
Many Greetings,

Norman

p.s .: Sorry for the bad English ;)

--- End quote ---

Railfan0311:
"Hello Norman,

You say you can see the GSX2 jetways only for a short period of time and then they dissapear?"


Hello.

That's right, when I reboot Coautl then the new jetways will load up and then they'll be gone.

Greet Norman

cartayna:

--- Quote from: Railfan0311 on February 14, 2019, 01:38:30 pm ---"Hello Norman,

You say you can see the GSX2 jetways only for a short period of time and then they dissapear?"


Hello.

That's right, when I reboot Coautl then the new jetways will load up and then they'll be gone.

Greet Norman

--- End quote ---
and what happens with the defalut jetways, are they still in the scenery?

Railfan0311:
Yes the standard jetways are there and after the reboot of coautl too.

cartayna:

--- Quote from: Railfan0311 on February 14, 2019, 03:42:08 pm ---Yes the standard jetways are there and after the reboot of coautl too.

--- End quote ---
ok, then you have forgotten step 3.
"THIRD: If you use the second step because you have not installed the Sode, then ignore this step In the FlyTampa Control Panel, select SODE Jetways. Go to the C:\ProgramData\12bPilot\SODE\xml folder and change the file extension of “FlyTampa_KBOS.xml” to “.off”

Navigation

[0] Message Index

[#] Next page

[*] Previous page