Products Support > GSX Sharing area - Airplane Configs

Leonard Maddog X

(1/3) > >>

blaunarwal:
Although supported by Leonardo there's still possibility to tune it. I added the rear stair to the configuration, which works perfectly. I remember having red from Leonardo, this shouldn't be possible due to GSX. For Ramp operations I don't see any problem. I didn't try what's happening on a jetway, the rear door closed.  ::)

Also to consider is the cargo doors mid and aft, that are close therefore the baggage trains collide. I had used the front cargo door. Maybe it was best to disable one cargo door and just do only the middle. At the moment, still both are active. Feel free to change. The code for the door has to be changed, if you want to use the fwd cargo door.



Make sure to let the gsx.cfg in the C:\Users\YourUserName\Documents\Prepar3D v4 Add-ons\MaddogX\SimObjects\Airplanes\MaddogX untouched. Put this into C:\Users\YourUserName\AppData\Roaming\Virtuali\Airplanes\MaddogX

virtuali:
We are working to add support for the rear stair in the proper way.

blaunarwal:
It's working perfectly with the standard door turned 90 degrees.

virtuali:

--- Quote from: blaunarwal on October 13, 2018, 01:47:57 pm ---It's working perfectly with the standard door turned 90 degrees.
--- End quote ---

Yes, of course it "works".

But proper support, means also detecting the stairway to be open and not let any passengers coming out of it (if it's not), and not sending a GSX staircase when it's closed either. This will require a small GSX update.

blaunarwal:
I see, that could be a problem at some types. So far no problem here with the MD-82. It's probably low enough to not trigger stairs. I also tested jetway operation with closed door in the back. Is also perfect operation.

I changed the cargo doors again, guessing the fwd variable right. So it works also in respect to the cargo trains, with enough space between them. Revised file below.

Navigation

[0] Message Index

[#] Next page