Products Support > GSX Sharing area - Scenery Configs
ImagineSim VIDP GSX L2 Compatible v1.1
karank:
--- Quote from: r22s7 on October 22, 2018, 11:37:10 pm ---https://image.ibb.co/gAycoA/vidp-jetways.jpg
Where have I gone wrong? I installed it as per the instructions, why are all my jetways detached from the terminal?
--- End quote ---
Hi, it seems like the scenery isn't loading up all the terminal structures in your sim. Could you check what your scenery density is set to? Turn it up to Dense/Very dense or higher and you should see an auxiliary building connected to the main terminal which is used for boarding/deboarding. The jetways are connected to this structure which is why it seems like they're attached to nothing right now.
The developer has set certain structures appear only when the density for airport autogen is set to a high setting in order to save on performance, most likely. You can edit this setting in the AFCAD through programs like Airport Design Editor and have all objects load up at a lower density.
The attachment below shows what it's supposed to look like.
r22s7:
--- Quote from: karank on October 23, 2018, 06:52:23 pm ---Hi, it seems like the scenery isn't loading up all the terminal structures in your sim. Could you check what your scenery density is set to? Turn it up to Dense/Very dense or higher and you should see an auxiliary building connected to the main terminal which is used for boarding/deboarding. The jetways are connected to this structure which is why it seems like they're attached to nothing right now.
The developer has set certain structures appear only when the density for airport autogen is set to a high setting in order to save on performance, most likely. You can edit this setting in the AFCAD through programs like Airport Design Editor and have all objects load up at a lower density.
The attachment below shows what it's supposed to look like.
--- End quote ---
Fixed it, I accidentally disabled the wrong BGL. :)
atrailblazer7:
Just curious...in naming ini file so GSX can read it...what do you name it? Example: C:\Program Files\Imagine Simulation\VIDP New Delhi P3Dv4\scenery
That is what mine is and the jetways still don't show. Did I miss something?
virtuali:
--- Quote from: atrailblazer7 on March 18, 2019, 11:08:25 am ---Just curious...in naming ini file so GSX can read it...what do you name it?
--- End quote ---
Look at Page 36 of the GSX manual, the chapter named "Note for scenery developers".
ashun:
Is new AFCAD valid for FSX or only for P3D
Thanks
Ash
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version