Products Support > GSX Sharing area - Scenery Configs
Flytampa Amsterdam Jetway replace GSX Level 2
DKE-STR:
--- Quote from: yvesamuel on September 26, 2018, 08:01:35 am ---If you look in the zip file, you will see that the afcad is the east acad. So you need to activate the east afcad throu FT configurator, rename in any name (.old for exemple), then copy the file ADEX_FLYTAMPA_EHAM_2016_EAST.bgl ain yous ../amstrrdam/scanery folder., and then it will work.
Yves
--- End quote ---
I did it, it still does not work.
simsuper80:
do i have to purchase gsx for the jetways to appear?
virtuali:
--- Quote from: simsuper80 on September 27, 2018, 06:05:06 pm ---do i have to purchase gsx for the jetways to appear?
--- End quote ---
Yes, to use a non-FSDT airport, you must own both GSX and the Level 2 expansion.
DKE-STR:
--- Quote from: DKE-STR on September 27, 2018, 02:46:11 pm ---
--- Quote from: yvesamuel on September 26, 2018, 08:01:35 am ---If you look in the zip file, you will see that the afcad is the east acad. So you need to activate the east afcad throu FT configurator, rename in any name (.old for exemple), then copy the file ADEX_FLYTAMPA_EHAM_2016_EAST.bgl ain yous ../amstrrdam/scanery folder., and then it will work.
Yves
--- End quote ---
I did it, it still does not work.
--- End quote ---
Now it work´s , but i have 2 Jetways there? How i remove it?
virtuali:
--- Quote from: DKE-STR on September 27, 2018, 10:22:56 pm ---Now it work´s , but i have 2 Jetways there? How i remove it?
--- End quote ---
Have you followed the video tutorial posted at the top of the GSX support section ?
It's made precisely at FlyTampa EHAM. Basically, you must start by excluding an existing jetway first, exit the sim, compile the exclude file with the GSX Control Panel, restart the sim, and the original jetway will disappear.
IF you downloaded a pre-made customization file, it's enough entering the customization page, and change anything (clicking twice on any one Exclude checkmark), will be enough to have the exclude XML source file to be recreated from the exclude areas in the .INI file you downloaded, so you can compile it.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version