General Category > Unofficial F/A-18 Acceleration Pack board

How to install to P3Dv4?

<< < (2/4) > >>

jimi08:
ctec1,

Copy all and thanks for the good feedback. 

Jimi

jimi08:
Alright,

Give this one a go.  I think I found and corrected the issues.

Link: https://drive.google.com/open?id=1FF6uavVqDkpSPRkWk9DjYM--dhF_LkyO

Jimi

ctec1:
Downloading now. Will let you know how it goes shortly. All I had to do to initialize the FCS was replace the existing HornetFCS.dll that was in the Panel.Fleet folder with the one from the Extras folder. That initialized the FCS but really I havent had a chance to fly it more than a few minutes.

Edit: Looks like you nailed it Jimi. The FCS initialized and the Readme file displayed properly at the end of the installation. The installer looks good. now to get out to the boat. THX Again!!!!!

jimi08:
Anytime!

ctec1:
Jimi,

You may need to take a look at the installer again. I tried to pull up the HUD Panel gauge (SHIFT+2) and got a message stating that the first two slots were not bound to anything. (SHIFT+3) and onward work but the first two gauges wouldnt open. I tried swapping the Panel.cfg from the Extras folder. What i got was working gauges but for some reason the HUD in VC Cockpit view is blank, like no power, although the HUD switch is in the on position. The 2D HUD gauge (SHIFT+1) is working but the HUD  wont display in VC view. I kinda recall something about this in the past but cant find the post. Is there someway to turn that HUD on? Hope this makes some sense.

Navigation

[0] Message Index

[#] Next page

[*] Previous page