General Category > General Discussion

Head scratchier... **SOLVED**

<< < (2/3) > >>

virtuali:
Then it might be a problem either caused again by OrbX, but with a different solution or, a problem caused by another scenery like that, with another solution as well.

The only thing sure, it's a problem caused by another scenery, which must be fixed by acting on that one. What sceneries you have installed which might affect the elevation ?

767 Pilot:
I have run the Orbix elevation adjuster numerous time and still get the same results, HOWEVER it did fix some of the other issues I had with some other sceneries.....I've come to the conclusion to just leave it as default and be done with it....or just maybe figure out whats wrong too...

Thank-you for your time!!
Doug

virtuali:
I'm not sure what you did with the OrbX AEC tool but, last time I heard from users, the problem was that it didn't support sceneries installed using the  proper P3D method (the add-on.xml method, opposed to the legacy scenery.cfg method), so it couldn't detect a scenery that require a fix for the elevation problem caused after installing their products. The solution was to select the affected airport manually.

I'm only reporting what I read from users that successfully solved the problem this way. I haven't tested it, because I have no OrbX product installed.

rjlfry:
I always do it manually as it will not always pick up some scenery addon, but once you have done it manually you cannot use the auto scan as it will reverse any manual edit you have done, and when you add an airport its the first thing you should do.
Ray Fry.

767 Pilot:
After some finessing with the manual installer and elevation I'm happy to say I finally got KMEM to show up!!! Yeah!  LOL

Anyway Virtuali and Ray Fry thank-you for your help!!!

Doug

Navigation

[0] Message Index

[#] Next page

[*] Previous page