General Category > Unofficial F/A-18 Acceleration Pack board

Location not selected Aerosoft Kittyhwak

(1/1)

Jorik:
Hi Guys,

Just installed vLSO for Prepar3Dv4.
But for some reason vLSO doesn't recognize the aerosoft kittyhawk and tells met the location is not selected.

Aerosoft F-14 install directory is in to the P3D addon location.

Could somebody help met out on this?

Best regards
Jorik

Paddles:
Most likely you have not tuned your NAV1 to the Kitty Hawk's frequency. Open the advanced settings window and on the NAV1 tab assign a frequency of your choice.

By default vLSO assigns NAV1 112.10 to the Kitty Hawk. However, Aerosoft F-14A and B use 109.00

Navigation

[0] Message Index