General Category > Unofficial F/A-18 Acceleration Pack board
FSXBA F/A-18C HORNET
PhantomTweak:
--- Quote ---...and never found the hook.
--- End quote ---
Did you try using the HOOK lever in the cockpit? Right side vertical panel, above the Cautions/Warnings panel? Hard to miss. Has a rectangular, red light above it to indicate it's down.
If it lowers the hook, go into you key assignments menu, and see if anything has changed it. Another add-on plane, an add-on gauge, or whatever, that you may not have noticed. Same for FSUIPC. If you have the payware version it can have this effect. Won't show in your key assignments menu, but it is in the FSUIPC information.
I don't have P3D, nor the payware version of FSUIPC, so I can't be more specific. Sorry about that.
Also, make sure you don't have any add-on program running alongside P3D that could capture that key assignment. A screen-cap program, a FBW add-on program, auto-trim, etc etc. Worth taking a look, anyway.
Hope something in all my babbling helps a little...
Pat☺
Corvette99:
Don't know why but,
water rudder is eject,
wing fold is refueling probe, and
tail hook is wing fold on my system .
I guess I have problems some where . I'll keep digging around.
The D ported over works perfect, so I'll keep looking.
And the hook handle folds the wings, although it says the hook went down. FYI the previous version also still works perfectly, just no MFD
Morti:
--- Quote from: Corvette99 on April 06, 2018, 09:14:40 pm ---Don't know why but,
water rudder is eject,
wing fold is refueling probe, and
tail hook is wing fold on my system .
I guess I have problems some where . I'll keep digging around.
The D ported over works perfect, so I'll keep looking.
And the hook handle folds the wings, although it says the hook went down. FYI the previous version also still works perfectly, just no MFD
--- End quote ---
Wow didn't know about ejection modelled!
Corvette99:
--- Quote from: Morti on April 07, 2018, 10:47:10 pm ---
--- Quote from: Corvette99 on April 06, 2018, 09:14:40 pm ---Don't know why but,
water rudder is eject,
wing fold is refueling probe, and
tail hook is wing fold on my system .
I guess I have problems some where . I'll keep digging around.
The D ported over works perfect, so I'll keep looking.
And the hook handle folds the wings, although it says the hook went down. FYI the previous version also still works perfectly, just no MFD
--- End quote ---
Wow didn't know about ejection modelled!
--- End quote ---
Great animation too. First canopy then the seat ! Looked great except I was downwind for the boat ! LOL
Creepy847:
Hi Jim thx for the update. I noticed a visual model issue if you pan around and look directly at your 6 oclock in the vc you will see that air-brake is not properly seated along the fuselage of the ac. It extends and retracts but does not seat fully in its stored position.
Other than that I have another issue but I need to look at the closer and see if its my side only.
Thank for your hard work.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version