General Category > General Discussion
Cargo Loaders
ozflyer:
When The cargo loaders finish, wiuld it be possible for each cargo loader to trigger thst particular door closure.
Sometimes the AFT cargo loader is completed and moves back to its position, while the FWD cargo loader is still continuing to load.
This leaves the AFT cargo soor open with no activity, which does not look natural.
Why cant each cargo loader trigger door closure as soon as its finished loading?.
Can it be done ?
Sent from my iPhone using Tapatalk
ozflyer:
Bump
Sent from my iPhone using Tapatalk
virtuali:
GSX doesn't close doors automatically, for a precise choice of NOT touching the aircraft systems, because there might be unexpected consequences if it tried to do that, like affecting non-standard airplane system related to the door itself (electrical or hydraulics).
ozflyer:
--- Quote from: virtuali on April 28, 2017, 09:24:26 am ---GSX doesn't close doors automatically, for a precise choice of NOT touching the aircraft systems, because there might be unexpected consequences if it tried to do that, like affecting non-standard airplane system related to the door itself (electrical or hydraulics).
--- End quote ---
Umberto - What I was requesting was that loader request closure ofvthe cargo door similar to open.
That way the pilot or virtual copilot ( i have multi crew experience) will close the individual cargo door as loading is completed. This just adds to a bit more realism.
It is odd seeing a cargo door left open with no activity. I do not think this is a huge effort to code that in maybe in the next update/parch ?.
Sent from my iPhone using Tapatalk
virtuali:
--- Quote from: ozflyer on April 28, 2017, 11:31:52 pm ---Umberto - What I was requesting was that loader request closure ofvthe cargo door similar to open.
--- End quote ---
It already does that. In fact, what you were reporting
--- Quote ---Sometimes the AFT cargo loader is completed and moves back to its position, while the FWD cargo loader is still continuing to load.
--- End quote ---
shouldn't normally happen in GSX, because a Cargo loader will not move back into position unless you close the Service door related to that vehicle. There are some cases when this might happen and are:
- You use a default airplane or any other airplane with both cargo doors sharing the same variables. In this case, GSX cannot ask you to close one of the door independently from the other, because they are not independent in the airplane itself.
OR
- You set a door as "Door with no open/close checks" in the GSX configuration editor, which means you told GSX to go ahead with services without checking for a door status.
These are the only cases where a cargo loader would move away without asking for the service door to be closed first.
Navigation
[0] Message Index
[#] Next page
Go to full version