General Category > General Discussion
P3D loading crash after last Addon Manager
Michael Apostrakis:
Same here… If I make a clean installation of GSX and start p3d it works fine… Then if I close the p3d and start it again p3d CTD…. I have tried more than 5 times….
virtuali:
--- Quote from: Michael Apostrakis on February 09, 2017, 10:05:14 pm ---Same here… If I make a clean installation of GSX and start p3d it works fine… Then if I close the p3d and start it again p3d CTD…. I have tried more than 5 times….
--- End quote ---
You mean it starts once normally, then it crashes on the 2nd start ? Are you using FSUIPC maybe ? If you don't use the very latest version which has been just released, it will surely crash P3D + Hotfix 3.
Michael Apostrakis:
Yes exactly... and I m using the latest version of FSUIPC. I dont had the problem before the latest update of GSX.
edwardpat:
--- Quote from: virtuali on February 09, 2017, 10:32:14 pm ---
--- Quote from: Michael Apostrakis on February 09, 2017, 10:05:14 pm ---Same here… If I make a clean installation of GSX and start p3d it works fine… Then if I close the p3d and start it again p3d CTD…. I have tried more than 5 times….
--- End quote ---
You mean it starts once normally, then it crashes on the 2nd start ? Are you using FSUIPC maybe ? If you don't use the very latest version which has been just released, it will surely crash P3D + Hotfix 3.
--- End quote ---
FSUIPC will crash any version of P3D, as I haven't (and will not) updated to HF3, unless you're using the very latest v4.962, which hopefully will not cause issues anymore.
Cheers, Ed
Drrick:
I had the same problem.... After installing GSX P3D started normally only once. After that P3D made a CTD. This remained even after deinstalling addon manager and GSX. I could not find the problem. I even reinstalled P3D without succes. It does CTD since then. All newest versions, and i do not use FSUIPC.
Gesendet von iPad mit Tapatalk
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version