General Category > General Discussion
P3D Hanging after update
virtuali:
--- Quote from: dunbar on February 06, 2017, 11:26:28 am ---Yes I can confirm this issue, I had the same experience / behavier on Friday last week and this is the cause why I registered me in this Forum here. I reinstalled my last HOtfixed
--- End quote ---
I had a Teamviewer session with the OP samwheeler, which had this crash after a few seconds when loading P3D.
It turned out to be GSX didn't had anything to do in this case, it's was a problem with FSUIPC crashing on start, which is known to Pete Dowson. As soon we removed it from startup, P3D loaded normally, with GSX and several other modules.
If you know how to disable FSUIPC from your DLL.XML file, you can try that and see if it fixes the problem. If it doesn't contact me in private to arrange a Teamviewer session, so we can see what's the problem in your case.
dunbar:
Thanks virtualli, I know, FSUIPC was updated recently, I had installed the new Version instantly. Best regrds dunbar
virtuali:
--- Quote from: dunbar on February 06, 2017, 11:44:34 am ---Thanks virtualli, I know, FSUIPC was updated recently, I had installed the new Version instantly. Best regrds dunbar
--- End quote ---
So you know the crash on startup has been acknowledged by Pete Dowson:
http://forum.simflight.com/topic/82771-p3d-crash-on-startup-or-on-exit-with-fsuipc-enabled/
Have you tried disabling it ?
dunbar:
--- Quote from: virtuali on February 06, 2017, 11:47:23 am ---
--- Quote from: dunbar on February 06, 2017, 11:44:34 am ---Thanks virtualli, I know, FSUIPC was updated recently, I had installed the new Version instantly. Best regrds dunbar
--- End quote ---
So you know the crash on startup has been acknowledged by Pete Dowson:
http://forum.simflight.com/topic/82771-p3d-crash-on-startup-or-on-exit-with-fsuipc-enabled/
Have you tried disabling it ?
--- End quote ---
not now, because I haven`t access to my computer at this moment. I will try it as soon as possible. best regrds, dunbar
dunbar:
--- Quote from: samwheeler on February 07, 2017, 02:51:13 am ---Again thanks so much Umberto. We need to give him more credit than he is getting. I reinstalled FSUIPC and sim is working fine! Thanks a lot Umberto! -Sam
--- End quote ---
Hi samwheeler,
Hi Umberto,
First I installed an older FSUIPC Version 4.96.
Then I started my P3d yesterday, GSX ask me for an update and I thought give it a chance. After this update I had the same behavior again. Unfortunately it screwed my P3d on more time. As I deleted the Prepar3d.cfg, started the P3d Startup Screen.
Any Ideas?
Best regards,
dunbar
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version