General Category > General Discussion
P3D Hanging after update
virtuali:
--- Quote from: dunbar on February 07, 2017, 09:21:31 am ---First I installed an older FSUIPC Version 4.96.
--- End quote ---
I don't think you understand: as of today, there's no FSUIPC version that supports the latest P3D Hotfix.
This is totally unrelated to GSX, since we don't use it for our software, and if you disable FSUIPC, I'm sure the sim will start normally with the latest GSX update.
dunbar:
--- Quote from: virtuali on February 07, 2017, 01:20:16 pm ---
--- Quote from: dunbar on February 07, 2017, 09:21:31 am ---First I installed an older FSUIPC Version 4.96.
--- End quote ---
I don't think you understand: as of today, there's no FSUIPC version that supports the latest P3D Hotfix.
This is totally unrelated to GSX, since we don't use it for our software, and if you disable FSUIPC, I'm sure the sim will start normally with the latest GSX update.
--- End quote ---
*Sorry* Yes I understand you not in the right way. Okay I will disable FSUIPC first and will look forward. Unfortunatly a lot of P3d Addons use FSUIPC?
All the Best,
regards, dunbar
virtuali:
--- Quote from: dunbar on February 07, 2017, 02:14:49 pm ---Okay I will disable FSUIPC first and will look forward. Unfortunatly a lot of P3d Addons use FSUIPC?
--- End quote ---
Well, at least ours do not. But I'm sure Pete Dowson will eventually find a solution.
Navigation
[0] Message Index
[*] Previous page
Go to full version