General Category > General Discussion
P3D v3.3.5 CTDs (ntdll) after KDFW install
virtuali:
--- Quote from: kikigey89 on October 13, 2016, 03:54:52 pm ---Good point, I forgot of the other set. Now FSUIPC is also disabled but still the same, still CTD.
--- End quote ---
Which airplane you used ?
kikigey89:
My own one (for my home cockpit), I made the flight dynamics, exterior model is Blackbox A330. Default FSX A321 cockpit.
virtuali:
--- Quote from: kikigey89 on October 13, 2016, 04:15:27 pm ---My own one (for my home cockpit), I made the flight dynamics, exterior model is Blackbox A330. Default FSX A321 cockpit.
--- End quote ---
So you are now running your home cockpit without any modules ?
kikigey89:
Exactly, I stripped it down to only the FS computer, without any external apps and just the dll and couatl.
virtuali:
--- Quote from: kikigey89 on October 13, 2016, 04:27:00 pm ---Exactly, I stripped it down to only the FS computer, without any external apps and just the dll and couatl.
--- End quote ---
Do you have an easy sequence to reproduce it with a default airplane ? I have just made a takeoff, a turn around the airport, then landed, taxied to Gate C6, called the GSX docking system, docked and turned off the engines, and I couldn't see any problems.
It took about 10 minutes, but you said it should appear in 5 minutes ? I'm using P3D 3.4 with the default B737 copied from FSX.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version