Products Support > GSX Sharing area - Scenery Configs

justsim lowi and GSX conflict

(1/2) > >>

virtualstuff:
With the just released Justsim Lowi unfortunately GSX doesn't detect any parking spots any solution with the next update?

Thanks for the support (PS love KMEM great stuff )

Cheers,

André

virtuali:
They probably using an auxiliary airport with a fake ICAO code, look in the GSX manual, the explanation of the "Airport Visibility" parameter.

noto1125:
Hi,

I am having the same issue and tried the Airport Visibility solution and it still did not work. When I used ADE to look at the .bgl file, it should very little airport detail.

Mind you I am not an expert in using ADE (quite the opposite) however I have used it to try and increase the Gate areas to accommodated heavy aircraft. So I am somewhat familiar with how it should look.

Any other suggestion?

Regards
Kenny

virtuali:

--- Quote from: noto1125 on September 08, 2016, 03:05:54 am ---I am having the same issue and tried the Airport Visibility solution and it still did not work. When I used ADE to look at the .bgl file, it should very little airport detail.
--- End quote ---

This is not very clear. Check which airport is used by GSX, using the customize airport position from the GSX menu.

noto1125:
Ok, it is the same airport Justsim's LOWI.  GSX shows a Bgl file in the Justsim's LOWI scenery folder and that was the one that showed no airport detail when I used ADE.  I tried the airport visibility option for the file hoping that the sim would then find the correct one, but it found none as the GSX menu did did show the customization option after. 

I hope I was able to communicate it better.

Regards

Navigation

[0] Message Index

[#] Next page