General Category > General Discussion
FSDT Sceneries with Estonia Migration Tool, error when entering legacy mode...
RAY VLASEK:
Recently went path of Prepar3d, producing excellent vivid graphics and excellent performance. The migration tool works fine for installations. However, one issue keeps occurring, when I try to use the migration tool in the legacy mode in order to utilize older aircraft, Prepar3d crashes on start up. The windows error log reports Faulting module path: C:\Prepar3D v2\bglmanx.dll, I have reported this error issue to Estonia support center, however maybe this has been seen before from other users.. thanks, any assistance would be helpful.... complete log attached...
virtuali:
You cannot use Legacy mode with any of our products, or any other products that supports and recognize P3D natively, because what the Legacy Mode does, is to conceal P3D to appear being FSX, so our module cannot recognize it as P3D, and this will surely cause a crash.
RAY VLASEK:
Thanks for speedy reply, in that case can I operate with dual install on same Hard drive, install of FSX and Prepar3d, with FSDT in each, would that require dual license of FSDT or are licenses good per user or per sim install...
pilot3033:
--- Quote from: rvlasek on March 07, 2015, 12:48:37 pm ---Thanks for speedy reply, in that case can I operate with dual install on same Hard drive, install of FSX and Prepar3d, with FSDT in each, would that require dual license of FSDT or are licenses good per user or per sim install...
--- End quote ---
I currently operate this way, with several FSDT products installed to both FSX and P3D on the same hard drive.
RAY VLASEK:
What is best way to have sceneries installed in both on same HD, just run installers in each or is there a way to share some files in order to save disk space....
Navigation
[0] Message Index
[#] Next page
Go to full version