General Category > General Discussion

P3D question to FSDT & iFly.

<< < (2/2)

Frank Lindberg:

--- Quote from: alexzar14 on March 02, 2015, 09:58:58 pm ---DX10! Thanks. As a matter of fact I just bought Steve's Fixer yesterday.

The other thing I figured (it was advised) - FTX Vector eats a lot of VAS. I thought, this is one thing I can give up when flying airliners (can't give up on scenery, aircraft and ASN, but Vector).

Yesterday I disabled the Vector and loaded the iFly-747 at the gate of JFK and woolla! 1.2 Gig constant, I took off ok with no leak.
So I assumed this success was awing to disabling Vector but by then I already had the DX10 fixer installed, so it might have ben that too.
Now I don't know what was really responsible for my success in greater degree (DX10 or Vector-OFF). Gotta do 2 experimental flights, one with Vector-on and one with off.



--- End quote ---

It's not DX10 ;-)

alexzar14:
A success!
FSDT JFK to KMIA (LatinVFR) with no OOM, Vector-disabled.
A bit upset to give up on Vector, but...

By the way,  on approach to KMIA at about 16000-18000ft I noticed a leak in VAS from a GIG down to 700 presumably because of KFLL, must have had it disabled for that flight. I guess I have to disable either of these two every time I use the other.

Navigation

[0] Message Index

[*] Previous page