Products Support > GSX Sharing area - Airplane Configs

Aerosoft Airbus X A318 A319 Config Files

<< < (2/3) > >>

costasaiko:
I´ve the last live update, but in P3D and FSX, with Aerosoft A318/A319, I only see one small crew transporter, no passenger buses, and one small cargo loader. Diferent from AAX A320 where I can see all the vehicles. What went wrong?

virtuali:

--- Quote from: costasaiko on October 03, 2014, 01:57:24 am ---I´ve the last live update, but in P3D and FSX, with Aerosoft A318/A319, I only see one small crew transporter, no passenger buses, and one small cargo loader. Diferent from AAX A320 where I can see all the vehicles. What went wrong?
--- End quote ---

As explained on the manual, GSX changes the type of passenger vehicle (bus or small van) depending on the estimated number of passengers on board, which is calculated by dividing the actual load by 200 lbs, which is an industry standard estimate of the average weight of a passenger + luggage. So, if GSX thinks you have very few passengers on board, it means you haven't loaded your airplane, so it's empty.

costasaiko:
Thanks for the answer, but i do the same to the AAX A320,  I load the airplane with the Aerosoft Airbus aplication, and in the A320 i have the buses but in the A319 i don´t. I go to the MCDU and load the cargo and passengers, and the zfw is correct.

virtuali:
I can't see why this can be a GSX problem: GSX just reads the actual payload from FSX using Simconnect, and it does it in the same way, regardless of the aircraft used, and it's not affected by the aircraft customization, it's entirely standard method, and since you said yourself it works with the A320, there's no reason why it won't with the A318, the only possible explanation is that the airplane WAS empty, for some reason, at least this is what the airplane reported to FSX.

And of course, just to be sure, I tried it both with the A318 and the A319, and there are no problems whatsoever, I can see the normal baggage train with 3 wagons, and the large passenger bus (which of course won't appear if there's a jetway), meaning GSX has got a normal payload figure from FSX, as it always did. No difference if I use or not the supplied fuel/load planner, it works in both cases.

hawele:
I've got the problem too. I also can only see a small van instead of a bus, despite of having loaded the plane(s) A318/19 with lots of passengers. After restarting GSX it seems to work, as in all (most?) cases the bus appears. Strange....
Regards, hawele

Navigation

[0] Message Index

[#] Next page

[*] Previous page