General Category > General Discussion

FlightBeam KDEN V1.2 install

(1/2) > >>

christiaan:
Have a lot of FSDT airports & from FlightBeam.

I am going to un-install KDEN Version 1 and install the new 1.2 (demo) version.

I presume I have to register the airport scenery again in the FSX Add-On programme.

As I do not want any issues, if asked to remove Add-on Manager & Coult can I ignore this message?

I do not want to mess up the airports installed.

Please advice.

Bruce Hamilton:
Be easier to grab the manual patch from the forum...

virtuali:

--- Quote from: christiaan on May 26, 2014, 11:42:07 pm ---I presume I have to register the airport scenery again in the FSX Add-On programme.
--- End quote ---

No, you will not. That's what the installer is for.


--- Quote ---As I do not want any issues, if asked to remove Add-on Manager & Coult can I ignore this message?
--- End quote ---

You usually WANT to ignore the message, especially considering you have other products requiring the modules because, the message will also warn you that if you remove the modules, no products requiring them will work.

You reply YES to the removal question, when you need to do a clean reinstall for troubleshooting reasons.

christiaan:
Thanks Virtuali,

Followed your advice.

Got the new version installed very quickly & easy.

juniormafia27:
Where do you see KDEN v1.2?

Navigation

[0] Message Index

[#] Next page